Polaroid 100 Series Repair Manual page 50

-
Models 100.240. 2S0, 3S0 & 360:
Replace the four beUows scn:ws.
-
All O.her Models:
Replace
the
four bellows fasteners using tool
-
#
II 050. (Use tweezers to replace retainer rings.)
Insert the fastener in the toof and hand..pres5 it in
place on the posts (Figure 5·9). (If a post breaks.
modify th~ camera according to the insrructions
contained in the '"'Bellows Replacement
n
pnr
cedure.)
., Extend the bellows and secure the U-frame
to tbe shutter housing by sliding the bushing
into the keyhole, Hook the smaller loop--end
of the spring onto the bushing.
J, Insert the sleeve on the shutter shaft (if pres- ­
ent) and slide the shaft into the housing.
Then secure the inner frame (bottom)
to
the
shutter shaft by repiadng the shutter shaft
screw and the two washers (if preseno,
Hook ihe spring around the shutter shaft.
-
4. App1y toc-Tite
cement
sparingly
to the
detent stud and secure the inner frame
(t0Pi
to the shutter shaft. Position the detent on
the detent stud so that the notched side is
FIG. 5.B REMOVING THE BELLOWS FASTENERS
cameras may have retaining rings which can be '
removed using tweezers.)
Replacement
1. Secure the new rear shutter to the beUows as
fonows (replace the light .seal):
-
HAIliD PflESS WITH
A TWISTING MOTION
-
-
-
-
-
FIG. 5.9 INSTALLING NEW FASTENERS
43