Table of Contents
Advertisement
Important Notice
Please be noted the camera Base Plate may loosen when you take out the camera from the pack. It
is because the Base Plate is attached to the Camera Body without locking tightly in order to simplify
the installation procedure.
Camera Body
The Base Plate is unlocked to the Camera Body.
1.
Stick the Template Plate on the position where you want to attach the camera, drill the
three holes on the Template Plate for screwing the camera with the supplied Screws and
Anchors, and the circle in the middle only if you want to wire the cables through the wall
/ ceiling (the "Line out" mark represents the factory wiring position).
2.
Insert the supplied three Anchors into the holes.
ED910/930 eZ.HD Indoor Dome Camera
Base Plate
8
Advertisement
Table of Contents
