Important Notice - EverFocus ED910F User Manual

Important Notice

Please be noted the camera Base Plate may loosen when you take out the camera from the pack. It
is because the Base Plate is attached to the Camera Body without twisting tightly in order to
simplify the installation procedure.
1. Stick the Template Plate on the position where you want to attach the camera, drill three
holes on the Template Plate for screwing the camera with the supplied Screws and Plastic
Anchors. If you wish to run the wires through the wall / ceiling, drill an additional hole in
the middle "Line out" circle position. Otherwise you can wire the cables from the side cut
of the camera (refer to the "Line out" arrow position).
2. Insert the supplied three Plastic Anchors into the three holes.
ED910F/ED930F eZ.HD Indoor Dome Camera
8