AEG Electrolux EMW2000 Service Manual page 82

Service Program
The configuration program
1
2
3
4
When the main circuit board is replaced, the spare circuit board must be configured anew.
A 16-digit code must be put in, which sets the variant of the appliance.
1. Access to the input mode:
ð Hold buttons 1 and 2 pressed simultaneously and turn the program selector by one position
to the right.
ð Hold the two selected buttons pressed until possibly a buzzer will sound and/or the LEDs and
the display give a running light.
ð Turn the program selector clock-wise to the last program position. The first digit A (see in the
display) will be indicated by the configuration code B (see in the display).
2. Changing the configuration code:
ð The desired configuration code for the first digit can be entered by pressing button 1.
ð By using button 2 the next digit can be requested.
ð If you have programmed all 16 digits, check all digits again for the correct configuration code
by pressing button 2 repeatedly.
3. Saving the configuration code:
ð Pressing buttons 1 and 2 simultaneously will save the entered configuration code. This is
confirmed by a buzzer or the flashing of all LEDs.
Washing appliances without a display indication
In appliances which have no display indication the digits A and the respective configuration code B are
indicated by the cycle run LEDs as a binary code.
For the digit (A) the upper four LEDs are responsible. For the configuration code (B) the lower four LEDs
are responsible.
Digits (A)
Configuration code (B)
TSE-N 01.03 A.B.
5
6
7
A B
ð
ð
LED OFF
LED ON
- 28 -
A
B
LEDs
valency
LEDs
valency
599 50 75 69 EN