Electronic Module
The electronic module, including the µP, controls various functions and is placed in a protective housing.
Functions:
-
Taking data of the selected cycle programs through the module.
-
Water level control in the tub; the level is recognized by the analog pressure switch and the heating
pressure switch.
-
Cycle temperature control by a NTC sensor.
-
Power supply of the heating element.
-
Power supply of the drive motor and control of its speed by the tachymetric generator.
-
Control of water inlet valves.
-
Control of drain pump, circulation pump, door lock and DSP (drum self position).
In case of a power failure the module saves the just paused cycle.
-
When the power supply to the appliance is restored again, the cycle starts where the program was
paused.
User Interface
The User Interface is placed inside the panel; it consists of the instruction and display module and the
program selector.
It is the communication interface between the user and the appliance.
It consists of:
-
The option buttons and the respective pilot lamps.
-
The time display and the alarm identification.
-
The Start/Pause button.
-
The Delayed Start button.
-
The program selector which also guarantees the ON/OFF function.
The program selector is connected to the instruction module by a flat line. And the instruction module is
connected to the main circuit board.
TSE-N 01.03 A.B.
- 8 -
599 50 75 69 EN