Transmitting A Call - Icom IC-F50V SERIES Operating Manual

2
OPERATION
I Transmitting a call
A total of 3 ways for code selection are available— selecting the
call code from memory, entering the call code from the keypad and
calling back from the queue channel record.
D D Using call memory
q While in the standby condition, push [P1] (Digital) to enter the
call code memory channel selection mode.
w Push [
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and
displayed during each call. However, an error beep sounds
and
"FAILED"
after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P3] (Moni(Audi)) to send the 'Clear down' signal.
6
Call code memory is displayed.
]/[ ] to select the desired call code.
is displayed when no answer back is received
is
"WAIT"