Operating The Buttons For Basic Function; Adjusting The Volume; Turning Attenuator On/Off; Switching Source Mode - Kenwood KVT-920DVD Instruction Manual

Operating the Buttons for Basic Function

V
O
L
V.SEL
A
Disc Slot
A

Adjusting the Volume

Press the 5 button to increase the volume.
Press the ∞ button to decrease the volume.

Turning Attenuator On/Off

B
This function allows you to turn down the
volume quickly.
Press the ATT button to switch the attenuator on
and off.
When the attenuator is on, the ATT indicator is
displayed.
When the attenuator is off, the volume returns to
the original level.
NOTE
Turning the volume up, or turning it all the way
down deactivates the attenuator function.
C

Switching Source Mode

Each time you press the SOURCE button to
switch source mode.

Inserting Discs

Holding the disc with the labelled side facing up, insert
it in the disc slot. The disc will start playing.
2CAUTION
• Do not insert other disks when a disk is already
inserted.It may damage the disk.
• When inserting a disc, be careful that the disc
does not touch the bottom of the monitor or the
mechanism. If it does, it may be scratched.
• Do not attempt to insert a disc into the slot if
another one is already there.
• The unit can only play 12-cm (5-inch) CDs. If you
insert an 8-cm (3-inch) CD, it will get stuck inside
and can cause the unit to malfunction.
D
Seeking / Searching
In Tuner Mode
Press the 4 button to make decreasing seeks.
Press the ¢ button to make increasing seeks.
In Disc Mode
Press the 4 button to search through the
chapters/tracks backwards.
Press the ¢ button to search through the
24
DISC/BAND
SCREEN
ATT TI
SOURCE
B
C D
V
O
L
EJECT
E
chapters/tracks forwards.
Fast Forwarding and Reversing Disc
D
Play
Fast Forwarding Disc Play
Hold down on the ¢ button.
Release your finger to play the disc at that point.
Reversing Disc Play
Hold down on the 4 button.
Release your finger to play the disc at the point.
E

Ejecting Discs

Press the EJECT button.
The disc stops playing and ejects from the slot.
NOTE
When you load a disc and eject it right away, the
next time you try to insert the disc may not load.
In such a situation, take the disc out for a
moment and then reinsert it.