Tx/ Rx Unit Rear Panel; Tx/ Rx Unit Sub-Panel - Kenwood TM-D710A Instruction Manual

TX/ RX UNIT REAR PANEl

q ANT
Connect an M-type (TM-D710A) or N-type (TM-D710E) external antenna to
this terminal. When making test transmissions, connect a dummy load in
place of the antenna. The antenna system or load should have an impedance
of 50 Ω.
w DATA
This is the data input/output terminal. Use a PG-5H (option) data
communications cable when connecting to the PC voice input/output terminal.
e PC
This terminal is for connecting to a PC. Use a PG-5G (option) cable or a
PG-5H (option) serial communications cable when connecting to a computer
D-SUB terminal.
r SP (SP 1/ SP 2)
If desired, connect 1 or 2 external speakers for clearer audio. These jacks
accept 3.5 mm (1/") diameter, 2-conductor plugs.
TX/ RX UNIT sUb PANEl
q MIC
Connect the supplied microphone to this jack.
w PANEL
Connect the Operation panel to this jack with using supplied Modular plug
cable.
14