Kenwood TH-K2AT Instruction Manual page 80

Using Priority Scan
1 Press [MENU] and turn the Tuning control to select
Menu No. 10 (PRI).
2 Press [MENU] and turn the Tuning control to select
"ON".
3 Press [MENU] to store the setting.
• "PRI" appears.
4 Press any key other than [PTT], [LAMP], and
[MONI/SQL] to exit Menu Mode.
• The transceiver checks for a signal on the Priority
Channel every 3 seconds.
• When the transceiver detects a signal on the Priority
Channel, "Pr" blinks and the frequency changes to the
Priority Channel.
• If you do not operate any control or key for 3 seconds
after the signal drops, the transceiver returns to the
original frequency and resumes Priority Scan.
5 To quit Priority Scan, select "OFF" in step 2.
• You can also press any key other than [PTT], [F],
[LAMP], [MONI/SQL], [F] then [MONI/SQL] and
[F] (1 s) to exit Priority Scan while "Pr" is blinking.
Note:
If a signal is received on a Priority Channel with a CTCSS or
DCS code programmed, the Priority Channel is recalled only
when the programmed tone/ code matches.
Press and hold [MONI/SQL] to pause Priority Scan when the
transceiver is not displaying the Priority Channel. Release
[MONI/SQL] to resume Priority Scan.
If you clear the Priority Channels {page 47}, Priority Scan stops.
If you press any key other than the following keys while "Pr" is
blinking, the transceiver exits Priority Scan: [LAMP],
[MONI/SQL], [F] (1 s), [F] then [MONI/SQL] (Squelch
adjustment) and [PTT].
66