Connecting The Antennas; Connecting The Speakers - Kenwood KRF-A4020 Instruction Manual

Connecting the antennas

Antenna terminal connections
1 Push lever. 2 Insert cord.
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as
possible from the receiver, TV set, speaker cords and power
cord, and adjust the direction for best reception.
FM indoor antenna
The supplied indoor antenna is for temporary use only. For
stable signal reception we recommend using an outdoor
antenna. Disconnect the indoor antenna when you connect
one outdoors.
FM outdoor antenna
Lead the 75 coaxial cable connected to the FM outdoor
antenna into the room and connect it to the FM 75 terminal.
ANTENNA
AM
GND
FM
75
Use an antenna adaptor
(Commercially available)
3 Return lever.
AM loop
antenna
FM indoor
antenna
FM outdoor antenna

Connecting the speakers

1 Strip coating.
3 Insert cord.
Front Speakers A
Left
Right
SPEAKERS
R
A
+ - -
+ - -
B
R
SUBWOOFER
Powered subwoofer
PRE OUT
• Never short circuit the + and – speaker cords.
• If the left and right speakers are connected inversely or the
speaker cords are connected with reversed polarity, the
sound will be unnatural with ambiguous acoustic imaging.
Be sure to connect the speakers correctly.
Speaker impedance
After confirming the speaker impedance indications printed
on the rear panel of the receiver, connect speakers with
matching impedance ratings. Using speakers with a rated
impedance other than that indicated on the rear panel of
the receiver could result in malfunctions or damage to the
speakers or receiver.
Setting up the system
KRF-A4020 (En/E2T)
2 Push lever.
4 Return lever.
Front Speakers B
Right Left
L
+
+
Use the FRONT
SPEAKERS B
L
terminals if you
want to connect a
second front
speaker system.
To produce sound from
the powered subwoofer,
turn the SPEAKERS A
key on. No sound will be
produced if only the
SPEAKERS B key is on.
5