Antennas; Connecting The Antennas - Kenwood VR-3100 Connection And Setup Manual

Chapter One : Connecting Your Devices
AM Loop Antenna
Your new receiver comes with an AM loop antenna for
AM radio reception. To connect the AM antenna:
1 . Insert the antenna loop into the base and position the
l o o p .
2 . Open the receiver's antenna terminal levers.
3 . Insert the antenna's wires into the terminal as shown
above.
4 . Close the antenna terminal levers to lock the wires in
p l a c e .
5 . Adjust the antenna loop as necessary to improve
reception.
To prevent hum interference, keep the AM antenna
wires away from speaker wires, AC power cords, the
TV chassis, and the receiver.

Connecting the Antennas

FM Indoor Antenna
Your new receiver also comes with an FM indoor
antenna for FM radio reception. To connect the FM
antenna:
1 . Attach the antenna sheath to the pole in the center of
the receiver's FM antenna jack, as shown above.
When you attach the sheath for the first time, you
may need to exert quite a bit of pressure.
2 . Adjust the antenna as necessary to improve recep-
t i o n .
3 . Tack the looped end of the antenna in the location
that provides the best reception.
Audio-Video Receiver VR-3100/VR-3090/KRF-V9992D
FM Outdoor Antenna
Kenwood recommends a permanently installed
outdoor FM antenna for best FM reception. To
connect an outdoor FM antenna:
1 . Connect the antenna wire to a standard,
commercially available antenna adapter as
shown above.
2 . Connect the adapter to the receiver's FM antenna
j a c k .
What if I Have Cable Radio?
If you have cable radio, contact your cable provider
for assistance with connecting to the VR-3100/VR-
3090/KRF-V9992D.
2 9