Connecting Antennas - Kenwood RV-7000 Instruction Manual

Connecting antennas

The broadcast reception cannot be made unless the antennas are connected. Connect the antennas correctly as instructed below.
FM indoor antenna
Fix on a wall, etc. with a good
reception condition.
The provided antenna is intended
for temporary use in indoors. To
obtain stable FM reception, it is
recommended to use an outdoor
antenna. Be sure to disconnect the
indoor antenna when an outdoor
antenna is installed.
AM loop antenna
Install in a position as apart as possible from this unit, the TV monitor,
personal computer, speaker cords and power cord, and place in an
orientation that can offer the best reception condition.
AM loop antenna AM loop antenna
1
Attach to the stand.
2
Push the lever.
3
Insert the antenna cord.
4
Release the lever.
26
RV-7000/RV-6000/RA-5000
6 0 - 5 8 2 7 - 0 8 _ 0 0 _ E n . i n d d 2 6
Insert into the groove.
Insert until the metallic
conductor becomes invisible.
FM antenna adapter
(commercially available)
FM outdoor antenna
(commercially available)
FM indoor antenna FM indoor antenna
1
Insert the antenna cord.
2
Fix the antenna on the wall.
FM outdoor antenna FM outdoor antenna
Lead the 75Ω coaxial cable connected to the FM outdoor antenna
into the room and connect it to the FM 75Ω terminal.
¤Caution for outdoor antenna installation
Since antenna installation necessitates skill and experience,
always consult your dealer before installation. The antenna
should be placed at a distance from the power distribution
wires. Otherwise, an electric shock accident may occur if the
antenna falls down.
1 0 . 8 . 3 1 1 : 0 7 : 5 6 A M