For cable routing information, see "Hot-plug, SATA drive support
board, SATA drive
—
Connect one end of the Mini-SAS cable to the backplane and the other end to an optional Smart
Array controller (SATA and SAS drive support).
For cable routing information, see "Hot-plug SATA and SAS drive support
controller card, SATA and SAS drive
Install the drives
("Drive
7.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
Install the air baffle (on page 20).
8.
Install the access panel (on page 19).
9.
Install the tower bezel (on page 17).
10.
Connect each power cord to the server.
11.
support" on page 61)."
support" on page 61)."
options" on page 28).
("Hot-plug cage to system
("Hot-plug cage to
Hardware options installation 33