Vivotek SD8333-E User Manual page 7

Status LED
Item LED status
1 Steady red
Red LED OFF
2 Steady red & Green
Steady red & Green
3 Red blinking every 0.15 sec. &
every 1 sec.
4 Red blinking every 0.15 sec. &
every 0.15 sec.
Hardware Reset
The reset button is used to reset the system or to restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the reset button with a paper clip or thin object. Wait for the Network
Camera to reboot.
Restore: Press and hold the reset button for at least ten seconds to restore system defaults.
Note that all settings will be restored to factory defaults.
SD/SDHC/SDXC Card Capacity
This network camera is compliant with SD/SDHC/SDXC 32GB, 64GB, and other preceding
standard SD cards.
blinking every 1 sec.
LED OFF
Green blinking
Green blinking
Description
Power on and system booting
Power off
Network normal (heartbeat)
Network failed
Upgrading firmware
Restoring default
VIVOTEK
User's Manual - 7