Disassembly and Reassembly > Disassembly
(11) DVD Drive Unit and R Case
1) Disconnect the fl at cable.
2) Remove the two screws [A].
3) Remove the two screws [G], and then remove the DVD drive unit (a).
Note:
The DVD drive unit is a precision component: Take great care when handling it. Do not subject the
DVD drive unit to any impact: Doing so could cause a fault.
Caution during disassembly and reassembly:
Be sure to paste the heat sink rubber (c): Neglecting this could cause a fault.
(a) DVD drive unit
(b) R case
(c) Heat sink rubber
(b)
1)
2) [A]
(a)
Fig. 5-3-11
5 - 10
Pull out
(c)
3) [G]
[A] M1.7×4
(Silver)
[G] M1.7×4
(Silver)