FUTABA 6J Instruction Manual page 13

(DFK WUDQVPLWWHU KDV DQ LQGLYLGXDOO\ DVVLJQHG XQLTXH LGHQWL¿FDWLRQ FRGH ,Q RUGHU WR VWDUW WKH RSHUDWLRQ WKH
UHFHLYHU PXVW EH OLQNHG ZLWK WKH LGHQWL¿FDWLRQ FRGH RI WKH WUDQVPLWWHU ZLWK ZKLFK LW LV EHLQJ SDLUHG 2QFH WKH
link is made, the ID code is stored in the receiver and no further linking is necessary unless the receiver is to
be used with another transmitter. In the case of this T6J transmitter/receiver set, the linking has already been
completed at the factory. However, it is always a good safety precaution to perform this linking procedure
once again, regardless.
,I \RX¶YH SXUFKDVHG D VSDUH RU DGGLWLRQDO UHFHLYHU LW ZLOO EH QHFHVVDU\ WR OLQN WKLV QHZ UHFHLYHU ZLWK \RXU
existing transmitter. In order to do so, follow the procedure below:
1) Place the transmitter and the receiver close to one another. Generally speaking, as long as the transmitter
DQG UHFHLYHU DUH ZLWKLQ  ´ RQH PHWHU  WKH OLQNLQJ SURFHGXUH ZLOO SURFHHG ZLWKRXW DQ\ GLI¿FXOWLHV
2) Turn on the transmitter.
3) Check the LED that is located on the face of the T6J transmitter. When the blue LED is on, and solid (no
blinking), the RF signal is being transmitted.
4) With power connected to the receiver turn on the receiver. The LED
on the face of the receiver will begin blinking.
 8VLQJ WKH SURYLGHG SODVWLF VFUHZGULYHU SUHVV GRZQ DQG KROG WKH ³6:´
switch on the receiver for more than one second. At this point, the
receiver/transmitter will start the linking operation.
 :KHQ WKH OLQNLQJ LV FRPSOHWH WKH /(' RQ WKH UHFHLYHU ZLOO FKDQJH WR VROLG JUHHQ 3OHDVH FRQ¿UP WKDW
the servos will now operate by your transmitter. Please refer to the table below for the LED status of the
UHFHLYHU¶V FRQGLWLRQ
No signal reception
Receiving signals
Receiving signals, but ID is unmatched
Unrecoverable failure (EEPROM, etc.)
LINKING PROCEDURE
Red: On
Green: On
Green: Blink
Red and Green turn on alternately
13