FUTABA 6J Instruction Manual page 50

UHFRPPHQGDWLRQV IRU WKH VW\OH RI ÀLJKW GHVLUHG
‡ Point 1 is shown initially which is throttle stick all the way downward (slow) position.
‡ Point 2 is the throttle stick approximately ¼ of the way advanced.
‡ Point 3 is the throttle stick approximately ½ of the way advanced.
‡ Point 4 is the throttle stick approximately 3/4 of the way advanced.
‡ Point 5 is throttle stick all the way upward (hi) position.
To set the idle up throttle curve:
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode. An audible double beep will be heard
and the default screen will change accordingly.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the idle up throttle curve (I-TH)
menu appears on screen.
 3XVK WKH '$7$ ,1387 OHYHU XSZDUG IRU  VHFRQGV 7KLV ZLOO FDXVH WKH ÀDVKLQJ
,1+ GLVSOD\ WR FKDQJH WR D ÀDVKLQJ 21 GLVSOD\ 1RZ WKH ,7+ IXQFWLRQ LV DFWLYDWHG
although depending upon the position of the idle up switch, it may not be on.
5) Push the SELECT key. The LCD screen will contain the throttle curve point
indication (left side of screen), as well as the current throttle curve value, expressed
as a percentage of travel, on the right side of the display.
Note: Point 1 is shown initially which is throttle stick all the way downward (slow)
position. Point 5 is throttle stick all the way upward (hi) position.
Press the DATA INPUT lever upward to increase the percentage of servo travel
for the respective point on the throttle curve. Press the DATA INPUT lever downward to decrease the
percentage of servo travel for the respective point on the throttle curve.
6) Press the SELECT button one time to bring up the point two (2) throttle curve adjustments. Again, use the
DATA INPUT lever to adjust the values accordingly.
7) Repeat the previous steps to set the idle up throttle curve point values for the remaining three (3) points.
8) Press the DATA INPUT lever either upward or downward to select Switch A, B or C as the idle up
activation switch.
50