Data Reset Function (Rest) - FUTABA 6J Instruction Manual

5) Use the SELECT key to choose the next character.
6) Repeat this procedure for the remaining two spaces. When completed, press and hold the END button.
&RQ¿UP WKH PRGHO QDPH RQ WKH KRPH SDJH

Data Reset function (REST)-

All the data for any model memory can be reset to the original factory defaults. Often this function is
SHUIRUPHG WR JHW D ³IUHVK VWDUW´ DQG FOHDU WKH PHPRU\ EHIRUH LQSXWWLQJ QHZ PRGHO VHWWLQJV ,W LV DOVR XVHG WR
HOLPLQDWH D PRGHO WKDW QR ORQJHU H[LVWV IURP WKH 7-¶V PRGHO PHPRU\
Note: Data reset function only resets the defaults for the model that appears on screen. It does NOT reset the
entire transmitter.
To reset data:
1) Turn the transmitter on. Ensure that the model on the home page is the one that is
to be reset.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the parameter (PARA) submenu
appears on screen.
4) Press the SELECT key until the model reset submenu (REST) is brought forth.
5) Press and hold the DATA INPUT upward or downward. The EXEC will begin
ÀDVKLQJ UDSLGO\ SULRU WR WKH PRGHO UHVHW EHLQJ H[HFXWHG 7KH 7- ZLOO DOVR HPLW DQ
DXGLEOH GRXEOH EHHS WR FRQ¿UP WKDW WKH PRGHO KDV EHHQ UHVHW
now been reset to the initial setting that is the default value set at the factory.
Note: If the power switch is turned off while reset is underway, the data may not be reset.
CAUTION: Resetting the current model memory will permanently erase ALL programming information for
that model. The data cannot be recovered (unless you recorded it in written form on a Model Data Recording
Sheet in the back of the manual). Do not reset the model unless you are certain you want to completely clear-
out that model memory and start from scratch.
Note: The reset function will NOT impact any other models, or model memory other than that indicated on
the LCD screen.
22
7KH PRGHO GDWD KDV