Adjusting The Motion Control Levers; Pushing The Machine By Hand - Toro TimeCutter MX 3450 74750 Operator's Manual

Riding mower
Table of Contents

Advertisement

Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or lower for
maximum operator comfort
A
g027252
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft
(Figure
secure the control in the new position.
3. Repeat the adjustment for the opposite control lever.

Pushing the Machine by Hand

Important: Always push the machine by hand. Never
tow the machine because damage may occur.
This machine has an electric brake mechanism and to push
the machine the ignition key needs to be in the Run position.
The battery needs to be charged and functioning for the
electric brake to be disengage.
To Push the Machine
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to park
position, stop the engine, and wait for all moving parts
to stop before leaving the operating position.
3. Locate the bypass levers on the frame on both sides of
the engine.
4. Move the bypass levers forward through the key hole
and down to lock them in place as shown in
Ensure this is done for each lever.
(Figure
22).
B
Figure 22
22). Tighten both bolts to
5. Move the motion control levers inward to the neutral
position and turn the ignition key to the run position.
Do not start the machine.
The machine is now able to be pushed by hand.
1. Bypass lever location
2. Lever position for
operating the machine
6. When finished, ensure the key has been returned to the
Stop position to avoid draining the battery charge.
If the machine fails to move the electric brake may still be
engaged. If necessary the electric brake can be released
manually. Refer to
To Operate the Machine
Move the bypass levers rearward through the key hole and
down to lock them in place as shown in
this is done for each lever.
Figure 23
.
21
1 2
Figure 23
3. Lever position for pushing
the machine
Releasing the Electric Brake (page
Figure
3
g017303
35).
23. Ensure

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents