Toshiba e-STUDIO163 Service Handbook page 91

[D] Secondary scanning data laser writing start position
This adjustment has to be performed for each paper source. (If there is no paper source, skip this step.)
The following table shows the order of the paper source to be adjusted, code, paper size and accept-
able values.
Order for
Paper source
adjustment
1 Drawer
2 PFU
3 Bypass feed
<Procedure>
While pressing [0] and [5] simultaneously, turn the power ON. Æ (Adjustment Mode)
(1)
Press [1] Æ [INTERRUPT] Æ [Drawer number] (Select from 0: bypass, 1: drawer or 2: PFU.) Æ
(2)
[START]. (A grid pattern with 10 mm squares is printed out.)
(3) Check the grid pattern on the test chart printed out and measure the distance D from the leading
edge of the paper to the 6th line of the grid pattern.
*Normally, the 1st line of the grid pattern is not printed.
(4) Check if the distance D is within 50±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance D again.
(Adjustment Mode) Æ (Key in the code shown above) Æ [START]
Æ (Key in an acceptable value shown above)
Æ [INTERRUPT] (Stored in memory)Æ "AJ" is displayed
Æ Press [1] Æ [INTERRUPT] Æ Press [Drawer number] Æ [START]
Æ (A grid pattern is printed out.)
*The larger the adjustment value is, the longer the distance D becomes (approx. 0.4 mm/step).
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Acceptable
Code Paper size
440 A3/LD
441 A4/LT
442 A4/LT
3 - 9
06/04
Remarks
value
0 to 40
0 to 40
0 to 15
e-STUDIO163/166/203/206
3
ADJUSTMENT