Adjustment Of The Adf (Mr-2017) - Toshiba e-STUDIO163 Service Handbook

3.10 Adjustment of the ADF (MR-2017)

3.10.1 Adjustment of ADF Position
Perform this adjustment when the ADF is not installed in the correct position.
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the ADF.
[A] Checking
(1) Open the ADF and install 2 positioning pins
(the positioning pins are installed to the back
side of the hinge which is on the left side of
the ADF).
(2) Remove the platen sheet.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 3-37
Fig. 3-38
3 - 45
e-STUDIO163/166/203/206
ADJUSTMENT
3