Disassembly Procedures; Disconnecting Wire Terminals; Door Assembly - Amana LD510D Service

Disassembly Procedures

!
High voltage is present at the high voltage terminal of
the high voltage transformer during any cooking cycle.
It is neither necessary or advisable to attempt
measurement of the high voltage circuitry.
Before touching any oven components or wiring, always
unplug the oven from its power source and discharge
the capacitor.

Disconnecting Wire Terminals

All wire terminals are locking-type terminals.
Proceed as follows to disconnect wire terminals:
Insulated terminals:
Grasp insulator pod and pull back.
DO NOT PULL ON WIRE.
1 Grasp
Insulator
Pod
Non-insulated terminals:
Use a small blade screwdriver to depress locking-tab
and pull on terminal.
DO NOT PULL ON WIRE.
1 Release
locking-tab
2 Pull
©2003 Maytag Appliances Company
WARNING
Wire
2 Pull
Wire
16022150 Rev. 0
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.

Door Assembly

!
CAUTION
A microwave leakage test must be performed anytime
a door assembly is removed, replaced, disassembled,
or adjusted for any reason.
Door Removal
1. Disconnect power to oven.
2. Open oven door, remove top hinge cap, and slowly
lift door to disengage the hinge pins at top and
bottom.
Top hinge cap
3. To re-install door, place bottom pin into slot first, then
align top pin.
4. Replace top hinge cap.
21