Disassembly Procedures - Amana A1200S Service

Disassembly Procedures

!
WARNING
Back Panel Removal/Service Position
1. Place the oven so there is something to support the
back panel when it is lowered.
2. Remove the four screws and lower the back panel to
an approximate horizontal position. The back panel
is now in the service position.
3. To remove back panel:
FS10 and VEND10
A. Disconnect H.V. wires to capacitor and diode.
B. Disconnect panel to chassis ground wire.
FS14
A. Disconnect panel to chassis ground wire.
B. Remove both voltage adjusting connector
assemblies.
!
CAUTION
To prevent possible electrical shock, this wire must be
reconnected when the back panel is replaced.
C. Power cord.
Cavity Lamp Replacement
1. Unplug the oven.
2. Remove screw and open the lamp access cover.
3. Replace the cavity lamp. Do not overtighten the
lamp.
Control Panel Assembly Removal
1. Loosen the 3/32" allen-head screw located near the
top of the control panel assembly.
2. Pull the control panel assembly forward and
disconnect the two wire connectors from the control
panel assembly.
To avoid risk of electrical shock, personal injury, or death,
disconnect power to unit and discharge capacitor(s)
before following any disassembly procedures.
Control Panel Disassembly
1. Remove the control panel assembly.
2. Disconnect the ribbon cable by applying even
pressure to both sides of the ribbon cable and pulling
outward from the ribbon cable connector.
3. Remove six screws and remove controller.
4. Pry off six clips and remove panel and display
window.
!
Static discharge can damage the controller. Avoid
touching any part of the circuitry on the back of the
controller.
Installation
1. Visually inspect ribbon cable silver circuit; if any silver
circuit is missing from the connector end of the ribbon
cable, evenly trim 1/16" off end of ribbon cable to
assure good electrical connection with ribbon cable
connector.
2. Apply even pressure to both sides of ribbon cable
while inserting cable into ribbon cable connector.
Visually inspect for proper alignment of silver circuit to
connector tabs.
21
CAUTION
RE220002 Rev. 6