Controller Removal (Electronic Models); Key Pad Removal; Timer Removal (Dial Models) - Amana LD510D Service

Disassembly Procedures
!

Controller Removal (Electronic Models)

1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Remove control panel, (see "Control Panel" section).
3. Disconnect keypad ribbon connector .
NOTE: Caution should be used when removing ribbon
from connector. Ribbon cable has two holes to
align and lock ribbon to connector.
4. Remove screws securing controller to control panel
assembly.
Control panel
Key pad
Button spring
Door release button
5. Reassemble in reverse order.
NOTE: Do not flex controller.

Key Pad Removal

1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Remove control panel, (see "Control Panel" section).
3. Disconnect ribbon connector.
4. Peel off failed key pad from control panel.
6. Reassemble in reverse order.
©2003 Maytag Appliances Company
WARNING
Controller
Release lever
16022150 Rev. 0
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.

Timer Removal (Dial Models)

1. Disconnect power to oven and remove outer case
(see "Outer Case" procedure).
2. Remove control panel, (see "Control Panel" section).
3. Remove screws securing timer to control panel.
4. Remove knob from timer.
5. Reassemble in reverse order.
Control panel
Tabs
Door release button
All Models
Door Release Lever / Release Button / Spring
1. Disconnect power to oven and remove outer case
(see "Outer Case" procedure).
2. Carefully pry tab on control panel to disengage
release lever from control panel.
3. Push (4) tabs on door release button and remove
button from control panel.
4. Remove spring from door release button.
5. Reassemble in reverse order.
Knob
Timer motor
Release lever
Button spring
23