Table of Contents
Advertisement
English
Motion Detection Area Configuration
To set the MOTION DETECTION AREA
In the MOTION DETECTION menu, select the AREA SETUP
(shown above) for the channel you wish to setup the MOTION
DETECTION AREA for.
You will see a grid of red boxes. The outlined boxes mark
•
the area that is sensitive to motion. The area without
the red outlines is not sensitive to motion.
•
Use the mouse to move the cursor around the screen.
•
By left clicking an area in the grid, you can toggle motion
detection ON or OFF in that location.
•
Click and drag to select the area you want to select or de-
select.
In the sample image above, a person entering the room
through the window would trigger the motion detection.
However, a person entering from the right of screen should
avoid the motion sensitive area. This is a good solution to
monitor the windows (left of image) without getting false
triggers every time someone enters the room from the right.
30
Sensitivity: The Sensitivity setting is controlled by a slider,
allowing you to set a value between L (low) and H (high). The
closer to H the slider is set, the more sensitive the motion
detection will be.
Full Screen: Will select the entire area for motion detection.
Clear: Will clear the entire area.
Get an able-bodied volunteer to move about in front of
the cameras you'd like to tune the sensitivity for. The ideal
sensitivity level is when your volunteer moving about always
triggers the motion detection, but there are no false triggers
(or very few) when your volunteer isn't moving about.
Advertisement
Table of Contents
