Assemble Starter Drive - Roll Pin Style With Plastic Cap - Briggs & Stratton Twin Cylinder L-Head Repair Manual

Assemble Starter Drive – Roll Pin Style With
Plastic Cap
1. Assemble starter clutch on armature shaft and
rotate clutch until it drops into place.
2. Install pinion gear with chamfered edge of pinion
gear teeth away from motor, Fig. 22.
3. Assemble spring retainer cup, return spring and
clutch retainer on armature shaft.
4. Press or drive NEW roll pin through retainer slot
and hole in armature shaft, Fig. 22. Roll pin should
be centered in armature shaft within 1/32"
(0.8 mm).
5. To install plastic cap, use a socket approximately
the same diameter as the plastic cap, for a driver
as shown in Fig. 23. Press cap in position. Cap
should lock in position when properly assembled.
8
6
COVER
CLUTCH
RETAINER
SPRING
RETAINER CUP
STARTER
CLUTCH
Fig. 22 – Assembling Starter Drive – Roll Pin Style
With Plastic Cap
Fig. 23 – Installing Plastic Cap
ROLL PIN
SLOT
UP
RETURN
SPRING
CHAMFERED
TEETH UP