Briggs & Stratton Twin Cylinder L-Head Repair Manual page 46

4. Assemble spring to fuel inlet valve, Fig. 36.
5. Install float assembly in upper body.
6. Invert upper body and check float height, Fig. 37.
7. Float should be parallel to gasket surface.
8. Bend tang to adjust, if necessary, using needle
nose pliers, Fig. 38.
9. Assemble new seal to throttle shaft and insert into
carburetor body, Fig. 39.
a. Install throttle plate with dimples up, opposite
idle port.
NOTE: Use LOCTITE 222 on screw threads.
3
NEEDLE NOSE
PLIERS
DIMPLES
FLOAT
SPRING
Fig. 36 – Install Float
SAME
FLOAT
Fig. 37 – Check Float Height
Fig. 38 – Adjust Float Height
IDLE
PORT
Fig. 39 – Install Throttle Shaft
FLOAT
TANG
13