Install Inlet Seat - Engines Built Before 98101500; Assemble Carburetor; Current Style - Type Nos. 1100 And Above Engines Built After 98101500 - Briggs & Stratton Twin Cylinder L-Head Repair Manual

2. Assemble 1/4" x 20 nut, 1/4" flat washer and fuel
tank spacer #94047 or #94038 to self threading
screw.
3. Thread assembly into seat.
4. Tighten nut until seat is removed, Fig. 24.
Install Inlet Seat – Engines Built Before
98101500
1. Insert new seat into carburetor body.
a. Seat has a starting lead.
2. Press in seat with #19135 driver, Fig. 25.
IMPORTANT: TO ENSURE proper float level be sure
seat is flush with carburetor body.

ASSEMBLE CARBURETOR

Current Style – Type Nos. 1100 And Above
Engines Built After 98101500
When assembling carburetor, use new new seals and
gaskets.
1. Install choke shaft.
2. Insert choke plate into choke shaft with offset slot
toward choke lever side.
3. Assemble body gasket to upper body as shown.
Be sure holes are aligned.
10
3
FUEL TANK
SPACER
Fig. 27 – Assemble Body Gasket
#92278 NUT
1/4" FLAT
WASHER
Fig. 24 – Remove Seat
PRESS
IN FLUSH
#19135
DRIVER
Fig. 25 – Install Seat
CHOKE PLATE
OFFSET
SLOT
Fig. 26 – Install Choke Shaft
CHOKE
SHAFT