Latch - DJG Alpha Omega All in One Instruction Manual

4358-4582 Alpha Omega 50lb 8/15/08
4
5
NOTE: Locking clip is
shown installed.
WARNING
!
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it, can result in
serious injury or death.
28
9:48 AM Page 31
Push down firmly on the
child restraint and pull up
on belt to tighten. For a
manual belt, refer to
"Knowing Your Vehicle
Belts" section. Pull up on
shoulder strap to remove
any slack.
With weakest hand at belt
path, tilt and push the child
restraint forward and back,
and from side to side. If the
seat belts do not loosen,
your child restraint should
be secure.
NOTE: Some "play" from
front to back or about an
inch from side to side is
acceptable. If it moves
more, review "Knowing
Your Vehicle Belts" and
"The Locking Clip"
sections.
After checking for hot seat
and buckles, secure child as
described in "Securing Your
Child in the Child
Restraint" section.
Rear-Facing Installation with
LATCH: Install LATCH Belt
Do not use the LATCH
1
system along with the
adult lap or lap/shoulder
belt.
To thread LATCH belts:
Pull the seat pad off the
front corners of shell.
LATCH adjuster can be
2
on either side, but belt
should not be twisted.
Route entire LATCH belt
through the upper slot in
side of shell.
Reach under pad, pull one
3
LATCH hook between
rear harness slot and
buckle strap.
29 continued on next page.