DJG Alpha Omega All in One Instruction Manual page 17

4358-4582 Alpha Omega 50lb 8/15/08
4
5
6
7
9:48 AM Page 33
Push LATCH hook
through the rear-facing
belt path slot.
Pull other end of LATCH
hook between buckle strap
and rear harness slot.
Push LATCH hook
through the other rear-
facing belt path slot.
Put seat pad back over
corners of shell.
Completed threading of
the LATCH system rear-
facing is shown.
30
Rear-Facing Installation with
LATCH: Install in Vehicle
Place child restraint rear-
1
facing in the back seat.
With child restraint in the
most reclined position,
make sure level lines on
shoulder belt positioning
guide are level with
ground. Adjust child
restraint if needed.
NOTE:
anchorage strap and hook
under the base or child
restraint.
Fasten one LATCH belt
2
hook to the anchor in the
vehicle seat located in the
vehicle seat bight. Repeat
for other side of child
restraint. See your vehicle
owner's manual for more
information.
Push down firmly on the
3
child restraint and pull up
on the loop to tighten belt.
31
Tuck top
continued on next page.