DeWalt XR LI-ION DCT416 Instruction Manual page 10

EN GLI SH
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack (a) with the rails inside the
handle.
2. Slide it firmly into place until you hear the lock
snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (p) and firmly pull the
battery pack out of the imaging thermometer
handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
Getting Started (fi g. 2)
1. Slide lens cover (g) down to expose the lens.
Power On/Off
1. To turn on the imaging thermometer, push
the menu/power button (l) and hold for 0.5
seconds.
2. To turn off the imaging thermometer, push the
menu/power button (l) and hold for 3 seconds.
INITIAL SETUP
Date and Time Setup
The first time the imaging thermometer is powered
on, it will prompt to set the time and date. After
the initial setup, the time and date can be changed
through the menu navigation.
1. Press the forward (j) or back (h) arrow to
highlight the field to change.
2. Press the select button (i) to activate the field.
The field will turn green.
3. Press the forward (j) or back (h) arrow to change
the activated field.
4. Press the select button (i) to save the changes.
5. Repeat the steps above to change the
remaining fields.
6. Press the menu/power button (l) to exit.
40
BASIC OPERATION
Main Viewing Screen
The main screen includes several sections:
r. Scanned Area Image
s. Temperature Measurement at Center of
Image (+)
t. Emissivity Setting
u. Battery Fuel Gauge
v. Temperature Color Scale
s
r
Image Blend
The DCT416 Imaging Thermometer has the ability to
display both a visual image and an infrared image.
The images can also be blended on the display to
provide an overlay of the thermal image on top of
the visual image. A blended image can be helpful
in diagnosing trouble spots or communicating with
customers.
To change the blend setting, push the image blend
adjust button (k). The image blend can be pushed
repeatedly to cycle through the following options for
display settings:
100% Visual
75% Visual, 25% Thermal
50% Visual, 50% Thermal
25% Visual, 75% Thermal
100% Thermal
Take and Store Photos (fig. 2)
Make sure a micro SD card is installed in order to
save a photo. Open micro SD card slot cover (d)
and insert the micro SD card into the slot (e).
1. Push photo capture button (m).
2. The displayed image will freeze for 3 seconds in
order to review the photo.
3. Press the forward (j) or back (h) arrow to
highlight save to SD card or delete.
u
t
v