Charmglow 720-0677 User Manual page 26

Figure 246
CSA INTERNATIONAL
Project 2078110
27 of 46
6. Use a flathead screwdriver to loosen the four screws locking
the bulb in place.
Loosen but do not remove the bottom two screws under the
light first.
Then loosen but not remove the upper two screws above
the light.
7. Pull out the light bulb and replace with a new bulb. Tighten
the four screws.
Note: Do not touch the halogen bulb with bare hands.
8. Replace the glass cover, reinsert light bulb housing into the
grill, and insert and lighten the screw.
Cleaning Method
Follow steps 1 through 4 above for glass cover removal. Use a damp towel to clean the surface of the
glass cover. Make sure the glass cover is completely dry before re-installing.
WARNING
Make sure the light switch is in the "OFF" position and the power plug is disconnected from
the power outlet prior to cleaning the glass cover.
WARNING
The light glass cover should not be in contact with water or any other liquid when it's warm.
Sudden change of temperature may cause cracks in the glass.
WARNING
To ensure continued protection against electric shock:
1. Connect to properly grounded outlets only.
2. Do not expose to rain.
3. Keep extension cord connections dry and off the ground.
26