System Q; Switching Preout; Built-In Amp Mute Control; Switching Dual Zone System Output - Kenwood Z828MP Instruction Manual

Menu settings

System Q

When this system is set to on, the System Q factors (Bass
centre frequency, Bass quality factor, Bass extend, Middle
centre frequency, Middle quality factor, and Treble centre
frequency) appear during the audio control mode.
Display and setting:
"System Q ON" : The System Q factors appear and can be
adjusted. (Default setting)
"System Q OFF" : The System Q factors do not appear.

Switching preout

Switch the preout between the rear and non-fading. When you
switch to non-fading, you can adjust the volume separately.
Display and setting:
"SWPRE Rear" : Rear preout (Default setting)
"SWPRE N-Fad" : Non-fading preout
NOTE
You cannot use the high-pass filter with non-fading preout.
Built-in Amp Mute Control <In Standby mode>
Toggles on or off the mute control on the built-in amplifier.
Turning on this control enhances the preout quality.
Display and setting:
"Builtin AMP Mute ON" : Built-in Amp Mute is ON.
"Builtin AMP Mute OFF" : Built-in Amp Mute is OFF. (Default
setting)

Switching Dual Zone System Output

You can select the speaker output, either front or rear, for the
TV(AUX) source.
Display and setting:
"Zone 2 Rear" : Output from the rear speaker (Default setting)
"Zone 2 Front" : Output from the front speaker
NOTE
Not available during the Dual zone system is on.

External Amp Control

Adjust the bass boost level of the external amplifier using the
main unit.
Display and setting:
"AMP Bass Flat" : Bass boost level is flat. (Default setting)
"AMP Bass +6" : Bass boost level is low (+6dB).
"AMP Bass +12" : Bass boost level is high (+12dB).
NOTE
As of December 2000, the power amplifiers controllable by the
main unit are as follows:
KAC-X501F/PS501F/X401M/PS401M/X301T/PS301T/X201T/PS201T
News Bulletin Function with PTY News Timeout
Setting
You can arrange to have news bulletins interrupt your current
listening source, including other radio stations. When the
News Bulletin function is on, the PTY News Timeout setting
allows you to set the interval during which further news
interruption cannot take place. You can adjust the PTY news
interruption period from 10 to 90 minutes for each journey.
— 42 —