Basic Operation; Powering On The Mvp-9000I; Intercom Microphone; Stylus - AMX MVP-9000i Operation And Reference Manual

Introduction

Basic Operation

The MVP-9000i is operated using its integral touchscreen, as well as the capacitive touch buttons on the left and the
directional pad on the right side of the device (FIG. 1). If the device has gone into its Sleep or Standby Modes, a button
press will awaken the device from Sleep Mode, but touching the screen is the only way to wake it from Standby Mode.
The MVP-9000i device's power use allows up to 72 hours of use between rechargings of its internal battery, but its
battery charge lasts up to one month if the device goes into Shutdown Mode during that time. The device may be placed
in its charging cradle at any time and operated within its cradle, making a wired Ethernet connection in the process.
If shut down, the device will power up when placed in a Table Docking Station or Wall Docking Station, or when
external power is applied via the PS3.0 Power Supply. If the device is in Standby Mode, the device will not turn on if its
side buttons or directional pad are touched or the device is docked. Touching the screen is the only way to wake an MVP-
9000i from Standby Mode.
Any wired connection intended for the device will be reconnected within approximately twenty seconds after the device
is placed in a Table Docking Station or Wall Docking Station. Depending upon its settings, the device may be set to go
into On Mode as soon as it is placed in the Docking Station.

Powering on the MVP-9000i

The MVP-9000i may be powered on by touching and holding the touchscreen. If the device was in Sleep Mode, it will
automatically turn on when put into a Table or Wall Docking Station.

Intercom Microphone

The MVP-9000i contains a built-in microphone above the upper lefthand corner of the touch screen for video and audio
conferencing capabilities. This microphone is concealed by the casing.

Stylus

The MVP-9000i comes with a unique touchscreen stylus that slides into a storage groove on the left side of the device
when not in use. Replacement styluses may be ordered in a 3-pack (black, FG5966-21; white, FG5966-22) from
www.amx.com.

Kick Stand

Since the MVP-9000i device is designed to be a unit used away from its docking station, it has an extendable "kickstand"
on the back of the unit (FIG. 2). This may be opened by physically lifting the free end of the kick stand away from the
device. The device may then be propped up on a flat surface and accessed in a normal fashion.

Audio/Video Capabilities

The MVP-9000i has the capability of displaying multiple JPEG and PNG files at one time. The device also supports
streaming motion JPEG video (of the sort used by many IP and Web cameras) and hardware acceleration of Motion
JPEG (previously configured in TPDesign4), as well as MP3 and WAV audio files.

Power Management

The MVP-9000i utilizes a dual voltage external power supply. It may be recharged through the supplied PS3.0 Power
Supply (FG423-30), as well as through the MVP-TDS-9 Table Docking Station (FG5967-1X) or the MVP-WDS-9 Wall
Docking Station (FG5967-1X). For more information, see the Accessories section on page 11 for details.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom 5