Off Wait Time Setting; Eject Angle Setting; System Q Setting; Switching Preout - Kenwood KDC-7024 Instruction Manual

Menu system

OFF Wait Time Setting

Setting the time until the faceplate hide operation starts after the
power is turned OFF.
The faceplate can be removed only during the set time period.
Display and Setting
"Off Wait 0s"
"Off Wait 3s" (Original setting)
"Off Wait 25s"

Eject angle setting

This function sets the opening and closing operation of a panel
when a disc is inserted and when it is ejected.
Display Setting
"Ejct Ang Slp" Opens and closes the panel while
maintaining the angle of the control panel
to the set angle.
"Ejct Ang Lvl" Opens and closes the panel after setting
the angle of the control panel to the
horizontal position.
<In Standby mode>
— 38 —

System Q Setting

Setting display/don't display for the System Q factors (Bass
center frequency, Bass Q factor, Bass extend, Middle center
frequency, Middle Q factor, and Treble center frequency) in
Audio control.
Display Setting
"System Q ON" The System Q factors are displayed.
"System Q OFF" The System Q factors aren't displayed.

Switching preout

Switching the preout between the rear and non-fading. (In non-
fading it outputs without effect from the fader control.)
Display
"SWPRE Rear"
"SWPRE N-Fad"

Built-in Amp Mute Setting

Toggles ON or OFF the mute control on the built-in amplifier.
Turning ON this control enhances the preout quality.
Display Setting
"AMP Mute OFF" The built-in amplifier activates.
"AMP Mute ON" The built-in amplifier deactivates.
<In Standby mode>
Setting
Rear preout.
Non-fading preout.
<In Standby mode>