Off Wait Time Setting; Eject Angle Setting; System Q Setting; Built-In Amp Mute Setting - Kenwood KDC-9023R Instruction Manual

2
Select the font
Press the [4] or [¢] button.
Dimmer
Dimming this unit's display automatically when the vehicle light
switch is turned ON.
Display
"Dimmer:ON"
"Dimmer:OFF"

OFF Wait Time Setting

Setting the time until the faceplate hide operation starts after the
power is turned OFF.
The faceplate can be removed only during the set time period.
Display and Setting
"Off Wait: 0sec"
"Off Wait: 3sec" (Original setting)
"Off Wait:25sec"

Eject angle setting

This function sets the opening and closing operation of a panel
when a disc is inserted and when it is ejected.
Setting
The display dims.
The display doesn't dim.
<In Standby mode>
— 41 —
Display Setting
"Ejct Angle:Slope" Opens and closes the panel while
maintaining the angle of the control panel
to the set angle.
"Ejct Angle:Level" Opens and closes the panel after setting
the angle of the control panel to the
horizontal position.

System Q Setting

Setting display/don't display for the System Q factors (Bass
center frequency, Bass Q factor, Bass extend, Middle center
frequency, Middle Q factor, and Treble center frequency) in
Audio control.
Display Setting
"System Q:ON" The System Q factors are displayed.
"System Q:OFF" The System Q factors aren't displayed.

Built-in Amp Mute Setting

Toggles ON or OFF the mute control on the built-in amplifier.
Turning ON this control enhances the preout quality.
Display Setting
"AMP Mute:OFF" The built-in amplifier activates.
"AMP Mute:ON" The built-in amplifier deactivates.
<In Standby mode>