Removing The Unit - Kenwood KDC-7024 Instruction Manual

• To attach this unit, make sure the front of the control panel faces you
and fit it into the mounting sleeve by pressing the four corners of the
hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing the
panel may result.
• The hollow at the center of the rubber frame is designed to make it
easier to remove discs.
If you do not want the hollow to be visible, mount the rubber frame in
the opposite direction (with the flat side at the top instead of the
bottom).

Removing the Unit

■ Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
2
When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
— 45 —
Lock
Catch