Oven Door Latch; Oven Door Removal; Oven Door Hinge Receiver; Door Disassembly - Jenn-Air JES8750AAB Service Manual

Electric slide-in range
Hide thumbs Also See for JES8750AAB:
Table of Contents

Advertisement

Disassembly Procedures
Door
Latch
Convection
Fan

Oven Door Latch

1. Remove control panel, see "Control Panel"
procedure.
2. Remove screws securing door latch to the front of the
oven cavity outer shell.
3. Remove screws securing door light switch to door
latch assembly.
4. Label and disconnect wire terminals from latch
assembly.
5. Reverse procedure to reinstall door latch assembly.

Oven Door Removal

!
WARNING
To avoid risk of personal injury or property damage,
do not lift oven door by the handle.
1. Open oven door and grasp door on both sides.
2. Lift up and off the hinge receivers.
3. Reverse procedure to reinstall oven door.
©2005 Maytag Services
Hi-Limit
Thermostat
Oven
Light
Switch
Door Hinge
Receiver
16025927
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
Oven Door Hinge
1. Remove power from unit.
2. Remove unit from installation position, see
"Removing and Replacing Range" procedure.
3. Remove oven door, see "Oven Door Removal"
procedure.
4. Remove front side trim, see "Front Side Trim"
procedure.
5. Remove the top and bottom screws securing hinge
receiver to the front frame.
6. Remove hinge receiver from oven chassis.
7. Reverse procedure to reinstall oven door hinge.

Door Disassembly

1. Remove oven door, see "Oven Door Removal"
procedure.
2. Place door on a protected surface.
3. Remove screws securing bottom trim to oven door.
4. Slide outer oven door glass and trim towards the
bottom of the oven door and remove.
5. Detach right and left trim pieces for outer door glass.
NOTE: Proceed with the following steps for door handle
and inner door disassembly.
6. Remove screws securing top door handle trim to
oven door chassis.
7. Remove screws securing door handle brackets to
inner door panel.
8. Lift upward on the lower side of the door handle to
release side alignment screws and rotate towards the
top of the oven door to release and remove.
9. Remove screws securing door handle to door handle
brackets.
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents