Front Side Trim; Convection Fan; Spark Module; Bottom Access Panel - Jenn-Air JGS8750ADB Service Manual

Disassembly Procedures

Front Side Trim

1. Remove power from unit.
2. Slide unit out far enough to access side trim.
3. Remove screws securing front side trim piece(s) to
oven chassis (left and right trim pieces).
4. Gently grasp trim piece with both hands, pull forward
and roll trim piece off retainer clips.
5. Reverse procedure to reinstall front side trim piece(s).

Convection Fan

1. Remove power from unit.
2. Remove screws securing convection motor cover to
oven chassis (screws at 12, 4 & 8 o'clock positions).
3. Remove screws securing convect motor to chassis.
4. Gently slide convection motor into oven cavity.
5. Label and disconnect electrical connection.
6. Replace and reverse procedure to reinstall motor.

Spark Module

1. Remove unit from installation position, see
"Removing and Replacing Range" procedure.
2. Remove screws securing lower rear access panel.
3. Disconnect and label wire connections from the spark
module.
4. Remove screws securing spark module to unit
chassis.
5. Replace and reverse procedure to reassemble.

Bottom Access Panel

1. Grasp top of bottom access panel and gently pull
down and out.
2. Reverse procedure to reinstall bottom access panel.

Indicator Lights

1. Remove control panel, see "Control Panel" procedure
for removal.
2. Label and disconnect wires from indicator light.
3. Squeeze the two tabs on the indicator light body and
gently pull to release from control panel.
4. Reverse procedure to reinstall indicator light.
©2005 Maytag Services
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas before servicing.

Hi-Limit Thermostat

1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screws securing hi-limit thermostat to oven
chassis.
3. Reverse procedure to reinstall hi-limit thermostat.
Door
Latch
Convection
Fan

Oven Door Latch

1. Remove control panel, see "Control Panel"
procedure.
2. Remove screws securing door latch to the front of the
oven cavity outer shell.
3. Remove screws securing door light switch to door
latch assembly.
4. Label and disconnect wire terminals from latch
assembly.
5. Reverse procedure to reinstall door latch assembly.
16022089
Hi-Limit
Thermostat
Oven
Light
Switch
Door Hinge
Receiver
25