Adjusting The Basic Machine; Positioning The Feed Dog - Pfaff 242 Service Manual

11

Adjusting the basic machine

.04
11

Positioning the feed dog

.04.01
Requirement
1. The feed dog must be the same distance from the left and the right side of the needle-
plate cutout.
2. When the longest stitch length is set, the front and rear point of reversal of the feed
dog in the needle-plate cutout must be equal.
4
Fig. 11 - 01
Loosen screws 1 and 2.
Adjust rock shaft 3 in accordance with requirement 1.
Tighten screw 1.
Set the longest stitch length.
Adjust rock shaft 3 in accordance with requirement 2 and tighten screws 2.
1
The flat sides of the pins 4 must face the screws 1, and the rock shaft 3 must
neither have any play nor bind.
Adjustment
X
X
2
3
4
1
11 - 2