Setting Up; Inserting The Needle In The Pfaff 242 And Pfaff 1242 - Pfaff 242 Service Manual

Setting up

9 Setting up
9 Inserting the needles in the PFAFF 242 and PFAFF 1242
.01
9 - 1
All regulations and instructions in this instruction manual are to be observed.
Special attention is to be paid to all Notes on Safety!
All setting up work is only to be carried out by appropriately trained personnel.
Before all preparation work, the machine is to be switched off at the on/off
switch or disconnected from the electricity supply by removing the plug from
the mains!
1
2
Fig. 9 - 01
The selection of the needle depends on the machine model and the materials
and threads being used (see Chapter 3 Specifications).
Turn the machine off!
Danger of injury if the machine
is started accidentally!
Use only system 134
Raise the needle bar as far as possible
and loosen screws 1.
Insert the needles 2 as far as possible
(the long needle groove of the left
1
needle must be facing right and that of
the right needle must be facing left).
Tighten screws 1.
2
134 needles. 134 134 134