System Q; Audio Control - Kenwood KDC-MP632U Instruction Manual

General features

System Q

Selecting the best sound setting preset for
different types of music.
1
Select the source to set
Press the [SRC] button.
2
Select the Sound type
Press the [Q] button.
When you press the button once, the current
sound setting is displayed.
Each time you press the button, the sound
setting alternates.
Sound setting
User memory*
Rock
Pops
Easy
Top 40
Jazz
Natural
• * User memory: The values set on the <Audio
Control> (page 12).
KDC-MP532U does not have the User memory
function so the values of Bass, Middle, and Treble set
in audio control are replaced to the System Q values
and "USER" is not displayed when the System Q
setting is changed.
• Change each setting value with the <Speaker
Setting> (page 14).
First, select the speaker type with the Speaker setting.
12
|
English
Display
"USER"
"ROCK"
"POPS"
"EASY"
"TOP 40"
"JAZZ"
"NATURAL"

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Basic Audio item
Turn the [VOL] knob.
Adjustment Item Display
Rear Volume * 1,2 "R-VOL"
1,3,4,5
Subwoofer level* "SW L"
6
Bass level* "BAS L"
6
Middle level* "MID L"
6
Treble level* "TRE L"
Balance "BAL"
5
Fader* "FAD"
Exit Audio Control mode (Volume control mode)
• * 1 Function of KDC-X590/MP632U.
• * 2 You can control this item when "2ZON" of <Audio
Setup> (page 14) is set to "ON".
• * 3 You can control this item when <Switching preout>
(page 30) is set to "SWPRE SW". (KDC-MP632U only)
4
• * You can control this item when <Subwoofer
Output> (page 15) is set to "SW ON".
5
• * You can control this item when "2ZON" of <Audio
Setup> (page 14) is set to "OFF".
6
• * You can adjust these items in detail. Refer to
<Adjusting the detail of Audio Control>(Page13).
(KDC-X590 only)
6
• * Source tone memory: Puts the set up value in the
memory per source. (Detail Audio item is included :
KDC-X590 only)
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob and
[ATT] button.
Range
0 — 35
–15 — +15
–8 — +8
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15