E-Mu Vintage Keys Operation Manual page 17

CONNECTIONS
••• Inserting a standard
mono phone plug halfway
into the jack allows you to
sum into the main outputs
without a special cable.
If a stereo plug is inserted, the Ring of the stereo plug serves as a signal
Return which sums into the Main outputs.
Therefore, the Sub 1 and Sub 2 jacks can serve as effect sends and
returns in order to further process selected instruments and then
return them to the main mix.
The diagram shows the Sub 1 and Sub 2 jacks being used as send/
returns in order to further process selected Vintage Keys presets with-
out using the effects bus on the mixing board. In a pinch, the effect
returns could also be used to sum additional instruments into the
main outputs.
Vintage Keys Output Section
R Bus
Tip
Ring
R
SUB 2
The Sub 1 and Sub 2 jacks can be used as effect returns to the Main Outputs.
POWER UP!
The power switch is located on the right side of the front panel. Vin-
tage Keys and its MIDI controller may be turned on in any order.
When power is applied, the liquid crystal display will light, indicating
that Vintage Keys is operating. You may have noticed that there is no
110/220 Volt power selector switch on Vintage Keys.
Vintage Keys automatically switches itself for 110 or 220 Volt
operation.
8 Vintage Keys Operation Manual
L Bus
Tip Tip
Ring Ring
L R
SUB 1
Tip Tip
Ring
L R
MAIN
Tip
Ring
L