E-Mu Vintage Keys Operation Manual page 115

MIDI SPECIFICATIONS
TRANSMITTED SYSTEM EXCLUSIVE COMMANDS
Command
Preset Data
Parameter Value
Tuning Table
Program Map Data F0 18 0A dd 07 ... ... F7
Configuration
Message
Instrument List
F7
Preset List
• Note 1 - Version Request
This command allows identification of machine type and software
revision. Vintage Keys will respond to the request with the version
data:
F0 18 0A dd 0B 01 r1 r2 r3 F7
r1, r2, r3 = software revision # in ascii (decimal point between r1 & r2).
• Note 2 - Configuration Message
This MIDI command is used to identify the sound sets in a given
Vintage Keys. The configuration request command is: F0 18 0A dd 0C
F7
Vintage Keys will respond to this command with the configuration
message: F0 18 0A dd 0D pl pm s1 l1 m1 s2 l2 m2 F7
where pl and pm are the lsb and msb of the total number of presets, s1
and s2 are the ID numbers of the sound sets contained in this unit,
and n1=l1, m1 and n2=l2, m2 represent the lsb and msb of the num-
ber of instruments in each sound set. If no expansion set is present, s2
will be 7F and n2 will be zero. Standard Vintage Keys Sound Set
= 6.
106 Vintage Keys Operation Manual
Message
F0 18 0A dd 01 ll mm ... ... CS F7
ll= preset # lsb mm = msb cs = checksum
F0 18 0A dd 03 pl pm vl vm F7
pl = parameter # lsb pm = msb
F0 18 0A dd 05 ... ... F7
F0 18 0A dd 0D pl pm s1 l1 m1 s2 l2 m2 F7
F0 18 0A dd 0F (14 bytes per instrument) ... ...
F0 18 0A dd 13 (13 bytes per preset) ... ... F7
Comments
vl = value lsb vm = msb
TT data = 256 bytes
see note 8
see note 2
see note 3
see note 4