Wall Mount/Rack Mount Installation - Bosch MON152CL30 Instruction Manual

MON152CL30 | Instruction Manual | Installation
6.3 Wall Mount/Rack Mount
Installation
The square mounting holes (75 mm (2.9 in.) centers)
can be used for rack mount installation or with wall
mount brackets (not provided) (refer to the Rack
Mount Kit Instructions).
6.3.1 Wall Mount Installation
1. Remove the MON152CL30 power supply/base
from the LCD panel section.
a. Unscrew the two (2) holding screws before
separating the base from the panel, as shown
in Photo A.
b. Carefully remove the power bayonet
connector (Figure 4, Item 1) from the panel
(see Photo B), while sliding the base off the
monitor.
Bosch Security Systems | April 12, 2006
Photo A
Photo B
2. Mount the unit to the mounting bracket (not
provided) using the four (4) mounting holes on
the rear panel. The square mounting hole
patterns are standard on 75 mm (2.9 in.) centers,
as shown in Photo C.
Photo C
6.3.2 Extension Cable Installation
Use the Extension Cable (included with the
MON152CL30) to place the power supply/base unit to
1.5 m (5 ft) from the LCD panel for wall mount or
rack mount installations.
1. Follow the instructions in Section 6.3.1, Step 1
to remove the power supply/base from the LCD
panel section.
2. Attach the power supply extension cable.
a. Connect one end of the extension cable
(large connector) to the power supply/base,
as shown in Photo D.
Photo D
EN | 9