Table of Contents
Advertisement
16
en | Installing the UML -202-90
6.2.2
Wall Mount Installation
The square mounting holes (100 mm (3.9 in.) centers) can be used for wall mount installation
using the optional UMM-LW-20B fixed mount or the UMM-LW-30B swivel/tilt mount.
Fig. 6.1 Mounting the Device
6.3
Connecting the Composite Video Signal to the Monitor
There are two (2) BNC connectors located on the rear side panel of the monitor for composite
video input and two (2) BNC connectors for composite video outputs (see Figure 3.2 on page
11).
NOTE: All video inputs are passive loop-through. The impedance is automatically set to
75 ohm by the input of the signal on the input connector, while operating in a single connec-
tion mode (see Figure 6.6 on page 19). If a cable is also connected to the output connector,
the video signal can be passed on to another monitor connected to it via the passive loop-
through function. Up to three (3) monitors may be connected in this manner (see Figure 6.7
on page 19).
NOTICE! To select between AV1 and AV2, press Input (see Figure 3.1 on page 10, Item 1)
i
located on the front of the monitor.
F01U076723 | 1.0 | 2007.09
Instruction Manual
UML -202-90
Bosch Security Systems, Inc.
Advertisement
Table of Contents
