Connecting The Composite Video Signal To The Monitor - Bosch MON152CL30 Instruction Manual

MON152CL30 | Instruction Manual | Installation
b. Connect the other end of the extension cable
(small connector) to the power input
connector on the rear side of the LCD panel,
as shown below in Photo E.
3. Connect the appropriate ends of the IEC power
cord to the power source (mains) and power
supply/base unit. Toggle the power switch on
the base to the ON position.
6.3.3 MON151PS Power Supply Installation
Use the MON151PS Power Supply (purchased
separately) to power the MON152CL30 unit's LCD
panel separately from the power supply/base unit. The
power source (mains) (120/230 VAC) can be located at
a distance of up to 3 m (10 ft) away. Use for a wall
mount or rack mount installation.
1. Follow the instructions in Section 6.3.1, Step 1
to remove the power supply/base from the LCD
panel section.
NOTE: The power supply/base unit may now be
stored, as it is no longer required to power the unit.
Bosch Security Systems | April 12, 2006
Photo E
2. Connect the bayonet connector from the power
supply to the power input connector on the rear
side of the LCD panel, as shown below in
Photo F.
Photo F
3. Connect the IEC power cord to the
MON151PS power supply unit.
4. Mount the LCD panel in its intended location.
5. Connect the power end of the IEC power cord
to the power supply source.
6.4 Connecting the Composite Video
Signal to the Monitor
There are two (2) BNC connectors located on the rear
of the monitor for composite video input and two (2)
BNC connectors for composite video outputs
(Figure 6).
NOTE: All video inputs are active loop-through. The
impedance is automatically set to 75 ohm by the input
of the signal on the input connector, while operating in
a single connection mode (Figure 8). If a cable is also
connected to the output connector, the video signal
can be passed on to another monitor connected to it
via the active loop-through function. Up to three (3)
monitors may be connected in this manner (Figure 9).
NOTE: To select between VIDEO1 and VIDEO2,
press Input (Figure 1, Item 1) located on the front of
the monitor.
EN | 10