JR 10X User Manual page 47

Indicates program Touch
being accessed to next screen
Touch to Touch
inhibit program to adjust the out
values
Touch
to activate exponential
Graphic Mixing Curve
The graphic mixing curve, located on the right side of your
screen, illustrates the mixing curve and is a useful reference tool
when adjusting or storing points. Up to 6 points can be stored at
desired positions, and these points can be moved up and down to
any desired position from 0 to 100%.
Adding New Points
Any time the +CL- keys (at the bottom of the screen) are replaced
by the STORE key on the LCD, you can set a new point on the
curve. Move the Master channel stick and note the vertical line
where the cursor is located can be moved to any desired position.
To store a new point, move the Master channel stick to the
desired position and touch STORE at the bottom of the screen.
Up to 6 points can be programmed and a high point and low point
are automatically entered into your transmitter.
Clear Operation
When the display cursor indicates that the Master channel is in
the position of a point that you wish to clear, you can push the CL
key or the + and - key simultaneously to clear the desired point.
Note: Only this point will be cleared from the transmitter.
As a result of removing one point, the other point numbers
change accordingly. Their values do not change, only their point
number.
In & Out
"In" refers to the actual stick position of your gimbal. "Out"
refers to the actual position of the slave servo. The range for
"out" is adjustable from -100 – +100. You are able to adjust the
output value by pressing the + or - keys to increase/decrease the
respective values. If you press either the CL or the + and - keys
simultaneously, you will reset the output value to 0.
Stick Position
This value is represented numerically just below the ENTER key
and changes to show the current stick position. You may find this
10X MANUAL Airplane
Touch to
to advance
exit program
Touch 0 to reset Graphic
the selected point mixing
to zero curve
useful when you want to move to the middle point position.
Exponential Function
An Exponential function allows you to smooth the selected curve.
Touch the SEL below the EXP to activate the exponential func-
tion.
Example screens:
EXPONENTIAL OFF
Accessing Switch Position Functions
Mixing can be assigned to several flight modes or switches. To
access the Switch Position function, press the PAGE key at the
top right of the mixing screen. Your screen will appear as fol-
lows:
Note: If you wish for this mix to always be on, adjust the
desired mix value in Pos 0 and leave all switches in Position 0.
Two mix values are available—Position 0 mix value and Position
1 mix value. If you desire an on/off setting, store the desired on
values under 1 and leave the Pos 0 values at 0%. Then select the
desired switch with which you wish to turn the mix on and off by
touching SEL until Position 1 is selected.
Note: Position 1 always has priority over Position 0 such that
if a switch or Flight Mode is assigned to POS1 and that Flight
Mode or switch is activated, Position 1 mix values will be in
effect.
To access the Include and Origin Mixing, switch position and
mixing with trim functions, press the PAGE key at the top center
of the mixing screen. Your screen will appear as follows:
EXPONENTIAL ON
47