JR 10X User Manual page 26

Now mixing will be activated only when this Flight Mode is
selected. Note: If all Flight Mode positions are critical (pose
significant risk for the aircraft), then use one of the other
switches for testing purposes.
4. Touch PAGE and select the type of mix (Normal, Include,
Origin) and whether or not the Trim feature is to be enabled.
5. Touch PAGE until the mixing percentage screen is displayed.
Move the Flight Mode switch (or the switch that was selected
in Step 3 above) until POS1 appears over the percentages.
6. Set the mix offset (if any) and set the mixing percentages as
may be appropriate for the desired mixing activity. Thoroughly
ground test the mix.
7. Fly the aircraft and test the mixer by selecting the Flight Mode
(or other switch that was used in step 3 above) that was indi-
cated as using POS1. Adjust the mixing parameters in the
Function Code that was used in step 1 to obtain the desired
results.
8. You may now return to the Programmable Mix (51-58) to pro-
gram the POS0 settings and/or to assign the mixing values to
other Flight Modes. Remember, in order to be able to turn mix-
ing off, either POS0 or POS1 values must be set to zero.
Indicates function being Touch
initial trimmer function
programmed
selection
Potentiometer/lever
which yields relative trim
Indicates
function above
relative trim
function
Indicates that trimmer
function is currently
inhibited
Trimmer Function (Flap)
The flap lever, when active, raises or lowers the flaps in unison
with one another.
To activate the flap lever, touch the PAGE key to get to the neces-
sary trim function, touch the
ACT
This portion of the screen will appear as follows:
LCD
Indicates relative
trim function
Lever which yields
trim function above
Indicates that
trimmer function is
currently active
Touch
the flap once again
Note: The flap trimmer function also appears when normal,
flaperon or elevon wing type is selected and can be inhibited or
activated as described above.
26
to return to Touch to
memorize data and exit
program
Touch to activate
the elevator right/left
(Alivator) trimmer
key under "flap."
to inhibit
With dual elevator active, the right side level can be utilized as
alivator trim lever (elevator halves in opposite directions). This is
helpful for adjusting loop tracking.
Touch to activate the
elevator right/left (Alivator) trimmer
10X MANUAL Airplane