JR 10X User Manual page 65

Note: If you have copied another pilot's program for his radio
controlled airplane, for the purpose of flying your own airplane,
be sure to familiarize yourself with all the set-ups. The receiving
model receives all data, modulation, servo travel direction, end
points (ATV), etc., from the transmit model. Failure to check
operation with your airplane may result in a crash.
Data Transfer Warnings
When the Data Transfer function is not working properly, the
counter display stops functioning. At this time, press the ST/SP
key and stop the transfer. Check to ensure that all DSC connec-
tions are properly fastened and that one radio is set up to transmit
data. If you cannot locate the problem, remove the trainer cord
from both systems and start the Data Transfer function again
from the beginning.
Even if the counter display has decreased to 0 and faded out,
there is a safety indicator to detect an error in the receive data.
This display will read as follows on the receive model:
This screen indicates that data transfer has not occurred properly.
Check to see if the trainer cord is properly inserted. Also, check
to see if the cord itself is functioning properly. Remove all kinks
and bends in the wire. If you cannot locate the difficulty, remove
the transfer cord from both systems and begin the Data Transfer
function once again.
The other warning will appear as follows:
Indicates the receiving transmitter
has received wrong data
This indicates that the receiving model has received improper
data, e.g., transfer of data from a 10X heli to a 10X airplane
radio. This type of transfer of data cannot be done.
10X MANUAL Airplane
65